Rockwell Automation FlexPak/WebPak 3000 DC Drive AutoMax Network Communication Board - Manual (Page 11)

Introduction 1-1
C
HAPTER
1
Introduction
This manual describes the AutoMax™ Network Communication Option Board
(M/N 915FK0101). This board enables a FlexPak™ 3000 or a WebPak™ 3000 DC
drive to be operated and monitored over the AutoMax network.
For normal operation, the drive can be completely controlled using the AutoMax
Network Option board. This allows use of only a network interface connection,
hardwired emergency stop, and three-phase input and output power wiring. Drive
control (such as start, stop, and reset), reference changes, parameter modification,
and drive monitoring can all be performed over the AutoMax network.
1.1 Before You Start
In this manual, parameters are shown by the parameter name used on the OIM ,
followed by the parameter number in parentheses. For example, the parameter to set
acceleration time, parameter P.001, is shown as
ACCELERATION TIME (P.001).
1.2 Where to Find Additional Information
You must be familiar with the instruction manuals that describe your system. This can
include, but is not limited to:
• FlexPak 3000 DC Drive Hardware Reference manual, D2-3404.
• FlexPak 3000 DC Drive Software Reference manual, D2-3405.
• WebPak 3000 DC Drive Hardware Reference manal, D2-3443.
• WebPak 3000 DC Drive Software Reference manual, D2-3444.
• AutoMax Network Communications Module manual, J2-3001.
• ReSource AutoMax Programming Executive Instruction manual (various part
numbers).
• Control and Configuration Software manual, D2-3348.
• WebPakCS Software manual, D2-3447.
1.3 Getting Assistance from Reliance Electric
If you have any questions or problems with the products described in this instruction
manual, contact your local Reliance Electric sales office. For technical assistance, call
1-800-726-8112.