Rockwell Automation FactoryTalk Metrics User Guide - Manual (Page 114)

Chapter 3 Collecting Performance Data
You will need to select the reporting value, if you have selected
the Collect Value at the Start and the End of the Event
option in "Configuring the Event Value (page 99)".
3. Under Event Severity Level, select one of the following
options:
• Do not record Severity Level for this Event.
• Specify a Severity Level for this Event.
If you select this option, you will need also to set the
severity level for the event from the following range: 0 =
very severe, 100 - not severe.
• Use the Severity Level from the selected Event Lookup
Code List for the collected event value.
This option is available if you selected an Event
Value/Reason Code Lookup List in "Configuring the Event
Value (page 99)".
If the event is collecting a value at the start of the event, at
the end of the event, or at the start and end of the event and
if the event is using a lookup list to provide a description of
the event value, you may choose to collect event severity
also from the lookup list. The severity levels that have been
associated with the values in the selected lookup list will be
used when recording severity for this event.
4. Under Additional Reporting Properties, select the Exclude
this event from the OEE Box report Machine Event list
option, if you do not want this event to be displayed in the
OEE Box report.
5. Click OK.
114 Rockwell Automation Publication PLTMT-UM001M-EN-P-June 2014