Rockwell Automation 1757-FFLDC4 FOUNDATION Fieldbus System User Manual - Manual (Page 54)

54 Rockwell Automation Publication 1757-UM012A-EN-P - July 2011
Chapter 3 Create an RSFieldbus Software Project
3. Do one of the following:
– To remove the link from the entire project, click Yes.
This action will also remove the block from the Process Cell window.
– To remove the link from the strategy only, click No.
This action hides the link. You can restore it, if necessary.
– To halt the deletion, click Cancel.
4. To restore links that have been deleted, right-click the block to which the
link was attached and choose Show Hidden Links.
Edit Line Links
Do these steps to change the way a link line is drawn.
1. Select the link.
2. Click the Modify icon .
3. Click a handle, or create a new one by clicking anywhere on the line, and
dragging it to the desired location.
Initial Position
Handles
Final Position
TIP Press Shift to draw lines at 45° and 135°.
Press Control to draw lines at 0° and 90°.