Rockwell Automation 1771-QDC, D17716.5.93(Passport) PLASTIC MOLDING MODULE - Manual (Page 87)

Chapter
7
7-1
Load Initial Configuration Values
This chapter helps you load the QDC module with machine-specific
configuration values by performing four tasks:
Determine initial configuration values
Record them on worksheets
Enter them in PLC-5 data table
Download them to the QDC module
Initial values that you load include:
configuration bits
set-output values
acceleration and deceleration ramp rates
pressure or velocity control limits
pressure or velocity gain constants
pressure alarm setpoints
We already recorded many initial values on worksheets for you.
Important: Do not start this chapter until you have:
spanned your sensors, and moved hydraulic cylinders (chapter 3)
jogged the ram (screw), clamp, and ejector (chapter 5)
Chapter Objectives