Rockwell Automation 1771-QDC, D17716.5.93(Passport) PLASTIC MOLDING MODULE - Manual (Page 81)

Select Command and Status Bits to
Sequence Machine Operation
Chapter 6
6-5
Table 6.E
Miscellaneous Status Bits To Trigger New Action
Reason for Using: Bit Description: QDC Block
Address:
ProĆSet
B34/xx:
To drop pump adders, or shift solenoids before
starting pack/hold profile
Injection complete SYS02ĆB04
To drop pump adders, or shift solenoids Clamp in moldĆprotect zone SYS03ĆB00 32
To add pump adders, or shift solenoids for tonnage
build or lockĆup
Mold safe SYS03ĆB01 33
To start inject cycle Tonnage complete SYS03ĆB02 34
To inhibit clamp from opening in auto mode Cure timer timing SYS03ĆB03 35
To start clampĆopen phase Ram (screw) retracted, and
Cure time complete
SYS03ĆB04,
and ĆB05
36,
37
To drop pump adders, or shift solenoids Clamp in openĆslow zone SYS03ĆB06 38
To idle the machine until starting next action Mold fully open SYS03ĆB07 39
To shift solenoids before starting next ejector stroke
after the 1st advance strode
Ejector profile stopped at end of stroke SYS03ĆB08 40
To prevent starting next cycle with machine in auto
mode
OpenĆdwell timer is timing SYS03ĆB09 41
To prevent starting ejector retract
until valves have shifted
Ejector forward dwell timer is timing SYS03ĆB10 42
To start next cycle with machine in auto mode Cycle complete SYS03ĆB11 43
To start ejector retract Ejector fully advanced SYS03ĆB12 44
To start ejector retract when tip stroking is ON Ejector is beyond tip advance position SYS03ĆB13 45
To start ejector advance when tip stroking is ON Ejector is within tip retract position SYS03ĆB14 46
To start ejector advance Ejector fully retracted SYS03ĆB15 47
To reĆopen the clamp when the part is stuck LP close watchdog timeĆout SYS04ĆB03 51
To idle the machine and activate an alarm because
the hopper is running out of plastic
Watchdog for plastication phase SYS04ĆB08 56
To shift solenoids for preĆdecompression SetĆoutput in progress @ end of hold SYS22ĆB06 342
To shift solenoids for plastication SetĆoutput in progress @ end of
preĆdecompression
SYS22ĆB07 343
To shift solenoids for postĆdecompression SetĆoutput in progress @ end of
plastication
SYS22ĆB08 344
To idle the machine until starting next action SetĆoutput in progress @ end of
postĆdecompression
SYS22ĆB09 345