Rockwell Automation 1771-QDC, D17716.5.93(Passport) PLASTIC MOLDING MODULE - Manual (Page 118)

Chapter
8
8-1
Load Initial Profile Setpoints
In this chapter you load the QDC module with profile setpoints by
performing four tasks:
Determine initial profile setpoints from text
Record them on worksheets
Enter them into PLC-5 data table
Download profile blocks to the QDC module
Initial profile setpoints that you load include:
control bits
velocity setpoints
pressure setpoints
position setpoints
timer presets
Important : Complete all previous chapters before starting this chapter.
The following table lists profile blocks and corresponding worksheets for
recording initial profile setpoints that you download to the QDC module.
To configure the QDC module
with this profile block
See this
Worksheet
On
Page
Clamp Close Profile Block (CPC) Worksheet 8-A 8-3
Injection Profile Command Block (IPC)
Worksheet 8-B 8-11
Pack/Hold Profile Command Block (HPC) Worksheet 8-C 8-19
Plastication Profile Command Block (PPC)
Worksheet 8-D 8-25
Clamp Open Profile Block (OPC) Worksheet 8-E 8-32
Ejector Profile Command Block (EPC) Worksheet 8ĆF 8-39
Take a moment to browse through a worksheet. It contains two parts:
control words for selecting parameters by setting bits
data words for recording initial profile setpoints
We present each worksheet followed by text telling you how to determine
initial setpoints. Complete one worksheet before going to the next. If you
need additional word/bit descriptions, refer to the Plastic Molding Module
Reference Manual (publication 1771-6.5.88).
Chapter Objectives
Use These Worksheets