Rockwell Automation 1771-QDC, D17716.5.93(Passport) PLASTIC MOLDING MODULE - Manual (Page 45)

Chapter
3
3-1
Configure the QDC Module's I/O
Your QDC module needs to know the characteristics of your ram (screw),
clamp, and ejector sensors. In this chapter, we describe how to determine
these characteristics and download them to the QDC module for the following:
signal ranges from pressure and position sensors
minimum and maximum sensor signals corresponding to
minimum and maximum pressures and positions
alarm values and travel limits
We describe how to configure the QDC module in these sections:
Select Module Parameters and I/O Ranges
Determine Initial Sensor-configuration Values
Download MCC Parameters to the QDC module
Use Set-output Mode to Move the Ram (screw), Clamp, and Ejector
Complete Your Sensor Configuration
Select Optional Configurations
Important: You must properly configure the QDC module using
procedures in this chapter before attempting further configurations.
Important: If you have not already done so, install Pro-Set 600 software.
The procedures in this and the next several chapters assume that you have
done so.
Chapter Objectives