Fc_warm_restart (fc byte = 0x0e), Fc_initialize_appl (fc byte = 0x10), Fc_start_appl (fc byte = 0x11) – Rockwell Automation 1766-Lxxxx MicroLogix 1400 Programmable Controllers User Manual User Manual
Page 269: Fc_stop_appl (fc byte = 0x12), Fc_enable_unsolicited (fc byte = 0x14), Fc_disable_unsolicited (fc byte = 0x15), Fc_delay_measure (fc byte = 0x17)

Rockwell Automation Publication 1766-UM001H-EN-P - May 2014
229
MicroLogix 1400 Distributed Network Protocol (DNP3) Appendix F
FC_WARM_RESTART (FC Byte = 0x0E)
14 - Warm Restart
This function code forces the MicroLogix 1400 to perform a partial reset.
This applies only to the MicroLogix 1400 Series B controller.
FC_INITIALIZE_APPL (FC Byte = 0x10)
16 - Initialize Application
This function code is used to initialize the user program which was downloaded
by RSLogix 500/RSLogix Micro software.
FC_START_APPL (FC Byte = 0x11)
17 - Start Application
This function code is used to start the user program which was downloaded by
RSLogix 500/RSLogix Micro software.
FC_STOP_APPL (FC Byte = 0x12)
18 - Stop Application
This function code is used to stop the user program which was downloaded by
RSLogix 500/RSLogix Micro.
FC_ENABLE_UNSOLICITED (FC Byte = 0x14)
20 - Enable Unsolicited Message
This function is used to dynamically enable unsolicited messages generated in the
MicroLogix 1400.
FC_DISABLE_UNSOLICITED (FC Byte = 0x15)
21 - Disable Unsolicited Message
This function is used to dynamically disable unsolicited messages generated in
the MicroLogix 1400.
FC_DELAY_MEASURE (FC Byte = 0x17)
23 - Delay Measurement, used for Non-LAN Procedure
This function code is used to measure the communication channel delay time.