Rockwell Automation 1766-Lxxxx MicroLogix 1400 Programmable Controllers User Manual - Manual (Page 125)

Rockwell Automation Publication 1766-UM001H-EN-P - May 2014 83
Using the LCD Chapter 5
6. Press the Left key twice. Then, the cursor will position at the third digit.
Press the Up key three times to change the third digit to 3.
7. Press the Left key once. Then, press the Up key once. The second digit will
change to "1". Note that "1" is still flashing, which means the cursor is still
at the data value position.
8. Press the Left key once. Then, press the Down key once. The sign digit will
change to "-", as shown below. Note that "-" is still flashing, which means
the cursor is still at the data value position.
9. Press OK to apply the changes. The new value -1300 is applied. Note that
the target word "0", which is to the right of "L9:", is flashing. The cursor is
moved automatically to the target word position.