Fc_direct_operate_nr (fc byte = 0x06), Fc_immed_freeze (fc byte = 0x07), Fc_immed_freeze_nr (fc byte = 0x08) – Rockwell Automation 1766-Lxxxx MicroLogix 1400 Programmable Controllers User Manual User Manual
Page 268: Fc_freeze_clear (fc byte = 0x09), Fc_freeze_clear_nr (fc byte = 0x0a), Fc_cold_restart (fc byte = 0x0d)

228
Rockwell Automation Publication 1766-UM001H-EN-P - May 2014
Appendix F MicroLogix 1400 Distributed Network Protocol (DNP3)
This direct operate function is similar to the FC_OPERATE function code
except that no preceding select command is required.
FC_DIRECT_OPERATE_NR (FC Byte = 0x06)
06 - Direct Operate No Resp
See the comment for FC_DIRECT_OPERATE. No response message is
returned when this request is issued from a DNP3 master.
FC_IMMED_FREEZE (FC Byte = 0x07)
07 - Immediate Freeze
Upon receiving a request with this function, the MicroLogix 1400 copies the
current value of a counter point to a separate memory location associated with the
same point. The copied value remains constant until the next freeze operation to
the same point.
FC_IMMED_FREEZE_NR (FC Byte = 0x08)
08 - Immediate Freeze No Resp
See the comment for FC_IMMED_FREEZE. No response message is returned
when this request is issued from a DNP3 master..
FC_FREEZE_CLEAR (FC Byte = 0x09)
09 - Freeze and Clear
Upon receiving a request with this function, the MicroLogix 1400 copies the
current value to the frozen value, then clears the current value to 0 immediately.
FC_FREEZE_CLEAR_NR (FC Byte = 0x0A)
10 - Freeze and Clear No Resp
See the comment for FC_FREEZE_CLEAR. No response message is returned
when this request is issued from a DNP3 master.
FC_COLD_RESTART (FC Byte = 0x0D)
13 - Cold Restart
This function code forces the MicroLogix 1400 to perform a complete restart
upon powering up.