Requirements for conforming installation, Filter – Rockwell Automation 1336F PLUS II User Manual - Firmware 1.xxx-6.xxx User Manual

Page 198

C–2

CE Conformity

Requirements for
Conforming Installation

The following six items are required for CE conformance:

1. Standard 1336

PLUS

Drive 0.37-448kW (0.5-600HP) CE com-

patible (Series D or higher).

2. Factory installed EMC enclosure (-AE option) or field installed

EMC Enclosure Kit (1336x-AEx - see page

C–3

3. Filter as called out below.

4. Grounding as shown on page

C–4

5. Input power (source to filter) and output power (filter to drive &

drive to motor) wiring must be braided, shielded cable with a cov-
erage of 75% or better, metal conduit or other with equivalent or
better attenuation, mounted with appropriate connectors. For
shielded cable it is recommended to use a compact strain relief
connector with double saddle clamp for filter and drive input and
compact strain relief connector with EMI protection for motor
output.

6. Control (I/O) and signal wiring must be in conduit or have shield-

ing with equivalent attenuation.

Filter

Filter Selection

Filter Catalog
Number

Filter
Series

Mounting

See . . .

Power
Dissipation

Three-Phase
Volts

Used with . . .

Frame
Reference