Rockwell Automation 1336F PLUS II User Manual - Firmware 1.xxx-6.xxx - Manual (Page 157)

Appendix
A
Specifications and
Supplemental Information
Specifications Protection
200-240V Drive 380-480V Drive 500-600V Drive
AC Input Overvoltage Trip: 285V AC 570V AC 690V AC
AC Input Undervoltage Trip: 138V AC 280V AC 343V AC
Bus Overvoltage Trip: 405V DC 810V DC 1013V DC
Bus Undervoltage Trip: 200V DC 400V DC 498V DC
Nominal Bus Voltage: 324V DC 648V DC 810V DC
Heat Sink Thermistor: Monitored by microprocessor overtemp trip.
Drive Overcurrent Trip
Software Current Limit: 20 to 160% of VT rated current.
Hardware Current Limit: 180 to 250% of VT rated current (dependent on drive rating).
Instantaneous Current Limit: 220 to 300% of VT rated current (dependent on drive rating).
Line transients: up to 6000 volts peak per IEEE C62.41-1991.
Control Logic Noise Immunity: Showering arc transients up to 1500 volts peak 2 .
Power Ride-Thru: 15 milliseconds at full load.
Logic Control Ride-Thru: 0.5 seconds minimum, 2 seconds typical.
Ground Fault Trip: Phase-to-ground on drive output.
Short Circuit Trip: Phase-to-phase on drive output.
Environment
Altitude: 1000 m (3300 ft) max. without derating.
Ambient Operating Temperature
IP00, Open: 0 to 50 degrees C (32 to 122 degrees F).
IP20, NEMA Type 1 Enclosed: 0 to 40 degrees C (32 to 104 degrees F).
IP54, NEMA Type 12 Enclosed: 0 to 40 degrees C (32 to 104 degrees F).
IP65, NEMA Type 4 Enclosed: 0 to 40 degrees C (32 to 104 degrees F).
Storage Temperature (all constructions): –40 to 70 degrees C (–40 to 158 degrees F).
Atmosphere Important: Drive must not be installed in an area where
the ambient atmosphere contains volatile or corrosive
gas, vapors or dust. If the drive is not going to be installed
for a period of time, it must be stored in an area where it
will not be exposed to a corrosive atmosphere.
Relative Humidity: 5 to 95% non-condensing.
Shock: 15G peak for 11ms duration (
±1.0ms).
Vibration: 0.006 inches (0.152 mm) displacement, 1G peak.
Agency Certification:
1 Note: Installation guidelines called out in Appendix C must be adhered to.
2 Applied noise impulses may be counted in addition to the standard pulse train causing erroneously high
[Pulse Freq] readings.
U.L. Listed
CSA Certified
Marked for all applicable directives 1
Emissions EN 50081-1
EN 50081-2
EN 55011 Class A
EN 55011 Class B
EN 61800-3
Immunity EN 50082-1
EN 50082-2
IEC 801-1, 2, 3, 4, 6, 8 per EN 50082-1, 2
EN 61800-3
Low Voltage EN 60204-1
PREN 50178

Q E T N O C D N I
6 L 6 5 D E T S IL

Q E T N O C D N I
6 L 6 5 D E T S IL