Rockwell Automation 1395 Digital DC Drive FRN 5-10.10/9.30 - Manual (Page 247)

Chapter 8
Start–Up
8-3
Figure 8.1
Bulletin 1395 Start-Up Sequence
External
Connection Checks
PRE-POWER CHECKS
Internal
Connection Checks
Feedback Board
Jumper Check
LIVE-POWER CHECKS
Incoming
Voltage Checks
Logic
Level Checks
Polarity
Checks
Monitor
Armature Voltage
PARAMETER PROGRAMMING
START-UP
With
Node Adapter
With
Discrete Adapter
TUNING
Pre-Power Checks
1. Verify all procedures listed in Chapter 6 Installation, have been
properly completed.
2. If you have not already done so, record the following information on
the Pre-Power Checklist Table on page 8-4.
•
Drive order number
•
Drive nameplate data
•
Motor nameplate data
•
Tachometer/Encoder data (if applicable)
•
Adapter boards used
•
External devices interfaced with Drive such as PLC, discrete I/O etc.