Rockwell Automation 1395 Digital DC Drive FRN 5-10.10/9.30 - Manual (Page 240)

Chapter 7
Programming Parameters
7-74
Parameter 906 – Trend Constant Logic Value [Trend Logic Val]
Internal units : None
Programming Terminal units: None
Minimum Value: 0000 0000 0000 0000
Maximum Value: 1111 1111 1111 1111
Default Value: 0000 0000 0000 0000
Description: This parameter specifies a bit(s) value used for trend
trigger evaluation. This parameter number is entered when
programming Trend Operand Parameter X or Y. The default value is
zero.
Parameter 907 – Trend Constant Logic Value [Trend Logic Val]
Internal units : None
Programming Terminal units: None
Minimum Value: 0000 0000 0000 0000
Maximum Value: 1111 1111 1111 1111
Default Value: 0000 0000 0000 0000
Description: This parameter specifies a bit(s) value used for trend
trigger evaluation. This parameter number is entered when
programming Trend Operand Parameter X or Y. The default value is
zero.
Parameter 908 – Trend Constant Unsigned Value [Trend Unsign
Val]
Internal units : None
Programming Terminal units: None
Minimum Value: 0
Maximum Value: 65535
Default Value: 0
Description: This parameter specifies an unsigned constant value
used for trend trigger evaluation. This parameter number is entered
when programming Trend Operand Parameter X or Y.
Parameter 909 – Trend Constant Unsigned Value [Trend Unsign
Val ]
Internal units : None
Programming Terminal units: None
Minimum Value: 0
Maximum Value: 65535
Default Value: 0
Description: This parameter specifies an unsigned constant value
used for trend trigger evaluation. This parameter number is entered
when programming Trend Operand Parameter X or Y.