Rockwell Automation 1395 Digital DC Drive FRN 5-10.10/9.30 - Manual (Page 238)

Chapter 7
Programming Parameters
7-72
Parameter 843 – SP Indirect 4 [SP Indirect 4]
Internal units : None
Programming Terminal units: None
Minimum Value: – 32767
Maximum Value: + 32767
Default Value: 0
Description: When programmed, appears as a constant Source
Parameter value at Parameter 13 and can be linked to a Sink
Parameter.
ATTENTION: For system indirect inputs, proper values, Min/ Max
limits and polarities must be observed. Entering incorrect values,
limits or polarities could cause the drive to operate in a runaway or
erractic condition.
Parameter 844 – SP Indirect 5 [SP Indirect 5]
Internal units : None
Programming Terminal units: None
Minimum Value: – 32767
Maximum Value: + 32767
Default Value: 0
Description: When programmed, appears as a constant Source
Parameter value at Parameter 14 and can be linked to a Sink
Parameter.
ATTENTION: For system indirect inputs, proper values, Min/ Max
limits and polarities must be observed. Entering incorrect values,
limits or polarities could cause the drive to operate in a runaway or
erractic condition.
Parameter 900 – Trend Constant Signed Value [Trend Sign Val]
Internal units : None
Programming Terminal units: None
Minimum Value: – 32767
Maximum Value: + 32767
Default Value: 0
Description: This parameter specifies a signed constant value used
for trend trigger evaluation. This parameter number is entered when
programming Trend Operand Parameter X or Y.
Parameter 901 – Trend Constant Signed Value [Trend Sign Val]
Internal units : None
Programming Terminal units: None
Minimum Value: – 32767
Maximum Value: + 32767
Default Value: 0
Description: This parameter specifies a signed constant value used
for trend trigger evaluation. This parameter number is entered when
programming Trend Operand Parameter X or Y.