Rockwell Automation 22-COMM-C ControlNet Adapter - Manual (Page 37)

Configuring the I/O 4-3
2. In the project tree, right-click the I/O Configuration folder and select
New Module. The Select Module Type screen ( Figure 4.3 ) appears.
Figure 4.3 Select Module Type Screen
3. In the list, select the ControlNet bridge used by your controller. In
this example ( Figure 4.3 ), we use a 1756-CNBR/D ControlNet
Bridge (Series D), so the 1756-CNBR/D option is selected.
4. Click OK. The Module Properties screen ( Figure 4.4 ) appears.
Figure 4.4 Module Properties Screen
5. Edit the following:
Box Setting
Name A name to identify the bridge.
Node Select the node address setting of the ControlNet bridge (default = 1).
Slot The slot of the ControlNet bridge in the rack.
Revision The minor revision of the firmware in the bridge. (You already set the
major revision by selecting the bridge series in Step 3.)
Step 3
Step 4