Rockwell Automation 22-COMM-C ControlNet Adapter - Manual (Page 19)

Chapter
2
Installing the Adapter
Chapter 2 provides instructions for installing the adapter in a PowerFlex
40 or PowerFlex 400 drive. This adapter can also be installed in a DSI
External Comms Kit. In this case, refer to the 22-XCOMM-DC-BASE
Installation Instructions (Publication No. 22COMM-IN001…) supplied
with the kit.
Before installing the adapter, verify that you have all required
equipment. Refer to
Chapter 1 , Getting Started .
Before installing the adapter, you must set its Operating Mode Jumper
for Single or Multi-Drive operation, and its Node Address Switches to a
unique ControlNet node address.
Important: New settings are recognized only when power is applied to
the adapter, or the adapter is reset. If you change a setting,
cycle power or reset the adapter to invoke the change.
Topic Page
Preparing for an Installation 2-1
Setting Operating Mode and Node Address Switches 2-1
Connecting the Adapter to the Network 2-3
Connecting the Adapter to the Drive 2-4
Applying Power 2-7
Preparing for an Installation
Setting Operating Mode and Node Address Switches
!
ATTENTION: Risk of equipment damage exists. The adapter
contains ESD (Electrostatic Discharge) sensitive parts that can be
damaged if you do not follow ESD control procedures. Static control
precautions are required when handling the adapter. If you are
unfamiliar with static control procedures, refer to Guarding Against
Electrostatic Damage, Publication 8000-4.5.2.