Installation – Sensaphone IMS-4000 Users manual User Manual
Page 88
IMS-4000 Manual
86
insTallaTion
This section provides information on:
• Operating environment
• Rack and tabletop installation
parTs reqUireD
Phillips Screwdriver
9 pin F/F null modem cable
Right-angle input power cable (1 included)*
*For additional right-angle power input cables, order part # IMS-4413.
operaTinG enVironMenT
Before you install the IMS-4302 PowerGate2 be sure that your operating environment meets the physical requirements of
the equipment.
Operating Temperature: 32º–122º Fahrenheit (0º–50º C)
Humidity: 5–90 %RH, non-condensing
Power: 120VAC 60 Hz outlet within 6'. Multiple 15A 120VAC outlets for powering equipment
Rack Requirements: Standard 19" equipment rack with supplied mounting bracket hardware.
Requires 1.0 EIA rack mount space.
Tabletop requirements: Flat area which can support an enclosure 17" wide by 10" deep by 2" high.
raCk MoUnT insTallaTion
The IMS-4302 PowerGate2 can be rack mounted using the included rack mount brackets. Follow the steps below:
1) Attach the rack-mount brackets to the PowerGate2 with a Phillips screwdriver.
2) Attach the unit to the equipment rack using two pan-head screws per side. Tighten the screws with a Phillips screw-
driver.
3) Plug the power cord into a 120VAC outlet.
Figure 3: Rack-mounted PowerGate2 Unit
TableTop insTallaTion
The IMS-4302 PowerGate2 can be installed on a tabletop or shelf. Follow the steps below:
1) Attach the four self-adhesive rubber feet to the four corners on the bottom of the IMS-4302.
2) Place the unit on a tabletop or shelf and connect the power cord into a 120VAC outlet.