Sensaphone IMS-4000 Users manual - Manual (Page 78)

IMS-4000 Manual
76
VoiCe alarM DialoUT
The IMS-4000 can call and deliver an alarm message in spoken English. After dialing, the unit will begin speaking “IMS-
4000 Alarm Message, Press any key to continue.” If the unit receives a touch-tone, it will recite the alarm message. When
it finishes speaking the message it will request acknowledgement (if the call type is Until Acknowledged; if the call type is
Inform, the unit will just speak the alarm message and disconnect). A sample Voice Alarm call is shown below:
“IMS-4000 Alarm Message, press any key to continue”
“IMS-4000 Alarm Message, press any key to continue” {call is answered and a 5 is pressed}
“IMS-4000 Alarm Message. The temperature is High at the IT Dept of XYZ Company.”
“Channel 1, temperature in the server room, is 81.5 Degrees Fahrenheit”
“Level exceeded limit of 80 Degrees Fahrenheit at 7:45PM.”
“Enter User Code:” {valid User Code is received}
“Alarm Acknowledged. Goodbye.”
perforMinG an ip pinG Via Telephone
The IMS-4000 allows you to perform an IP Ping during a voice call-in to the Host. After dialing the unit, press a touch-tone
after the beep. The unit will request your User Code. Next, listen to the menu choices. Option 3 will allow you to enter an IP
address in numeric dot-quad format. Use the * key for a dot. A sample IP Ping is shown below:
“Hello this is the IMS-4000 at the IT Dept of XYZ Company.”
“Enter your User Code:” {valid User Code is received}
“To hear the environmental status, press 1.”
“To hear the IP status, press 2.”
“To ping an IP device press 3.” {3 is received}
“Enter IP address, Use the star key for dot. Press pound (#) when finished.”
{user enters 10.1.4.17}
“Pinging now...”
“10.1.4.17 is not responding”
Call-in alarM aCknowleDGMenT
If you receive an alarm message on your pager or in your voice mail, you can still acknowledge the alarm by calling the unit
back and entering your User Code. Note that the Intercall Delay must be set to at least 1 minute in order for the unit to
answer a call.
When you call in to the unit, wait for the beep and then press a button on your touch-tone telephone. If there are unac-
knowledged alarms in the User’s class, the unit will say “Unacknowledged alarms exist. To hear the alarms, press 9.” If you
press 9, the IMS will announce all unacknowledged alarms that are in the User’s class. When the unit finishes announc-
ing all of the alarms, it will say “Enter your user code.” If the user code is entered correctly the unit will say “Alarm
acknowledged” and it will acknowledge all of the alarms announced, and stop dialing all contacts programmed as “Until
Acknowledged” type.
reMoTe loGin Via DialUp
You can remotely connect to the IMS-4000 via modem using Windows Dial-up Networking. This is a standard utility
included with the Windows operating system. Follow the instructions below according to your installed operating system to
set up Dial-up Networking.
windows 95 and 98
To configure Dial-up Networking, double-click on My Computer from the desktop or click the Start button and select Progr
ams>Accessories>Communications>Dialup Networking. Click on Make New Connection. Follow the prompts to configure this
connection. You will need to enter a name (“IMS-4000,” for example), choose your modem, and enter the telephone number
of your IMS-4000. When you’re finished, an icon should appear with the name you provided. Double-click on this icon.