Sensaphone IMS-4000 Users manual - Manual (Page 50)

IMS-4000 Manual
48
special notes
To reset a Smoke detector alarm, you must momentarily disconnect it from the Host or Node, and then reconnect it. This
will silence the alarm and return it to normal operating condition.
ConfiGUrinG TeMplaTes
Environmental input programming Templates are used to load user-specified defaults each time a new sensor is connected
to a Host or Node. By properly configuring the Templates before you plug in your sensors, you can minimize the amount
of programming required to set up your sensors. To configure the Templates, click the plus box next to the word Settings to
expand the options under this heading. Next, expand the Input Templates. This will list all of the different sensor types.
Figure 24: Template Types
Right-click on each of the sensor names to bring up the individual Template programming screens. An example is shown
below.
Figure 25: Template
ConfiGUrinG ip alarMs
ip alarM seTUp
Each host or node can monitor up to 64 IP addresses through pinging and port availability. In addition, IP dependencies
can be programmed to prevent multiple alarm messages from being sent when common network paths are down.