beautypg.com

Sensaphone IMS-4000 Users manual User Manual

Page 120

background image

IMS-4000 Manual

118

Mounting

The Dry Contact Bridge can be mounted to a wall or lie flat on the floor. To mount it to a wall, install the two drywall

anchors (if necessary) and attach the bridge using the two #6 tapping screws. When installing the sensor on the floor, attach

the four rubber feet to the bottom of the enclosure.

Figure 2: Mounting the sensor

Configuration

All IMS Solution sensors are auto-configured when you plug them into the Host or Node. When a new sensor is plugged

into the Host or Node, the configuration is set to the factory default via the Sensor Template. If you have modified these

templates, the configuration will be set to the modified configuration. When a sensor is removed, or the connection is dis-

rupted, the configuration data remains intact but the sensor will go into trouble status and generate a trouble alarm. When

the sensor is plugged in again, or the connection is re-established, configuration data remains unchanged and the sensor

returns to normal operating condition.

Caution: Removing a sensor for less than 60 seconds does not produce a trouble alarm. Removing or

unplugging a sensor for more than 60 seconds or plugging in a different sensor at any time will cause a trouble

alarm.

sensor Template (factory default)

specifications

Input Name: Contact Bridge

Recognition Time: 3 Seconds

Reset Time: 0 Seconds

Data Logging: Active

Voice: dry contact.wav

Input Class: Other

Input: Normally Open or Normally Closed dry

contact

Source/Sense Voltage: 14VDC
Source/Sense Current: 10mA

IMS Connection: RJ-45

Operating Temperature

Range: 32° to 122°F (0° to 50°C)

Housing: Black plastic with mounting ears