Sensaphone IMS-4000 Users manual User Manual
Page 25
23
Chapter 1: Installation
If you select Option 1 you will see the IP address and status of the Host and all associated nodes. A sample is shown below:
Enterprise Status
Unit
Type IP
Status
IMS-4000 Monitor Host 10.1.4.10
Ok
NY_Node
Node 10.1.4.17
Ok
Press any key to return to main menu
Option 2 will display the network configuration for the Host as well as web server, RAS, and two-way email settings. A
sample of Option 2 is shown below:
Network and Option Configuration
Physical
Address
00:D0:C9:37:40:86
IP
Address
10.1.4.10
Subnet
Mask
255.255.255.0
Default
Gateway
10.1.4.1
DNS
Server
10.1.2.111
Enterprise name
U.S. Widgets Inc.
Web
Server
Enabled
Web Status Security
Enabled
Web Programming Option
Enabled
Web Programming Security
Enabled
Remote Access Server
Enabled
RAS IP Port Address
0.0.0.0
Two-Way E-mail Responder
Enabled
Microphone
Listen-in
Enabled
Datamodem
Enabled
SNMP
RO
community
public
SNMP
RW
community
private
SNMP
Agent
Enabled
Allow remote configuration
Disabled
Press any key to return to main menu
Option 3 will allow you to set all pertinent network settings listed under Option 2.
NOTE: You can remotely reconfigure the Host network settings using the IMS-4000 ConsoleView software if the Allow
Remote Configuration option is set to Y. However, the Host must initially be configured via the serial port before any
remote configuration is possible.
Option 4 allows you to configure or reconfigure the Enterprise name.
Option 5 allows you to configure the Web server. When Web security is enabled, a Profile Username & Password must be
entered to view the web page. A sample of the Web configuration menu is shown below:
Configure Web Server
1. Enable Web Server: Y/N
2. Enable Web Status Security: Y/N
3. Enable Web Programming option: Y/N
4. Enable Web Programming Security: Y/N
5. Return to main menu
Option 6 allows you to configure the RAS (Remote Access Server). This can be used to provide remote access to your net-
work via a dial-up connection to the IMS-4000 Host. Note that there are serious security risks associated with enabling this
feature. A sample of the RAS menu is shown below:
Configure Remote Access Server
1. Enable/Disable RAS Support
2. RAS IP address
3. Return to main menu
Enter option->
Option 7 allows you to Enable or Disable the two-way email feature.
Option 8 allows you to monitor on-site sound through either the built-in or an external microphone.