Sensaphone IMS-4000 Users manual - Manual (Page 79)

77
Chapter 3: Operation
Enter a Username and Password which matches a Profile Username and Password in your IMS-4000. Click Connect to have
your modem dial up your IMS-4000.
Note: If Dialup Networking is not listed it may not be installed on your computer, in which case you will need to use
your Windows installation CD to add it.
windows 2000
To configure Dial-up Networking, double-click on My Computer from the desktop or click the Start button and select
Settings>Control Panel. Double-click on the icon called Network and Dialup Connections. Double-click on Make New
Connection. Follow the prompts to create a new connection. For the Network Connection Type choose Dial-up to Private
Network. Enter the telephone number of your IMS unit and assign a name to the connection (“IMS-4000,” for example).
When prompted to enter your Username and Password be sure to enter information which matches a Profile Username and
Password in your IMS-4000.
Note: If Dialup Networking is not listed it may not be installed on your computer, in which case you will need to use
your Windows installation CD to add it.
windows xp
To configure Dial-up Networking, double-click on My Computer, then select My Network Places, then View Network
Connections. Select Create a New Connection or click on the Start button, then Programs>Accessories>Communications>New
Connection Wizard. Follow the prompts to create a new connection. On the Network Connection Type screen, select Connect
to the Network at my Workplace. For the network connection choose Dial-up. Enter a name for the connection (“IMS-
4000,” for example) and the IMS-4000 telephone number when prompted. Finish the setup. When prompted to enter your
Username and Password be sure to enter information which matches a Profile Username and Password in your IMS-4000.
CoMMUniCaTinG wiTh yoUr iMs-4000
Double-click on the Dial-up Networking icon you just created above. This should make your computer dial your IMS-4000
and connect. Once a connection is established, run the IMS-4000 ConsoleView Software by double-clicking on the IMS-
4000 icon on your desktop. At this point you should be communicating with your IMS-4000. To disconnect, close the IMS-
4000 Software and then disconnect the Dial-up Networking connect