SATEC EM132-133 Manual - Manual (Page 93)

‎Chapter 5 Configuring T H E E M 1 3 X S E R I E S
EM13x Series SMART MULTIFUNCTION METER 93
Click OK, and then send your new setup to the meter, or save to the
device database.
To define the contents of the file:
Highlight the data log file row with the left mouse button, and then
click on the Setup Recorder button, or click on the Data Recorder
tab and select the corresponding log number.
Figure ‎5-19: Log Setup Dialog Box – Data Recorder Tab
Configure the list of parameters to be recorded in a log file. You are
not allowed to select more parameters than you defined when
configuring your file. Refer to Appendix D for a list of available
parameters.
For your convenience, PAS follows your selection and helps you
configure a series of the neighboring parameters: when you open the
Group box for the next parameter, PAS highlights the same group as
in your previous selection; if you select this group again, PAS
automatically updates the Parameter box with the following
parameter in the group.
Add the name for your data log file in the Name box. It will appear in
the data log reports.
Save your new setup to the device database, and send it to the meter.
Billing/TOU Daily Profile Log File
Data log #16 is configurable to store TOU daily profile log records on a
daily basis.
The file is organized as a multi-section file that has a separate section
of the same structure for each billing energy and maximum demand
register. The number of sections is taken automatically from the
Billing/TOU Registers setup (see
Configuring Billing/Tariff Registers ). If the
maximum demand profiling is used, then the number of sections in the
file will be twice the number of the allocated billing registers.
To configure a daily profile log file:
Configure your Billing/TOU registers and tariff schedule in the meter
(see
Configuring Billing/Tariff Registers ) first.