SATEC EM132-133 Manual - Manual (Page 85)

‎Chapter 5 Configuring T H E E M 1 3 X S E R I E S
EM13x Series SMART MULTIFUNCTION METER 85
Using the Front Display
Select the Access entry from the main menu. See Viewing and
Changing Setup Options in Chapter 3 for information on configuring
parameters via the front display.
To change the password:
 Apply LONG PRESS on ENTER button to select the
Passwrd 1 entry
 Apply SHORT PRESS on ENTER button to select the
password digit to change.
 Apply LONG PRESS on ENTER button to exit the
Passwrd 1 digit field
 Apply LONG PRESS on ENTER button to exit the
Passwrd 1 field to move to Access field
The new password is effective for both the display and
communication ports.
Using PAS
Ensure that the On-line button on the PAS toolbar is checked, select
Administration from the Monitor menu, and then select Change
Password -> Password 1.
An Authorization Required dialog box will ask for
administrator password to access the Change Password
menu.
Figure ‎5-14: Password Setup Dialog Box
To change the password:
 Type in a new 8-digit password
 Repeat the password in the Confirm new password
box
 Click Send
Access Passwrd 1
9
LONG PRESS
Access Passwrd 1
00000009
SHORT PRESS