Configuring the em13x series remotely – SATEC EM132-133 Manual User Manual
Page 6

6
EM13x Series SMART MULTIFUNCTION METER
Assembling the 12DI/4RO module
To operate the EM13X Series:
Perform device diagnostics.
Configure the device through the EM13X Series unit
front panel display.
Configuring the EM13X Series remotely
Install the PAS application software on your PC.
Configure the PAS database for your meter.
Configure the PAS communications settings.
Upgrade the meter firmware if a new version is
available.
Set up the meter using the PAS application software.
Configure your security settings through the meter
security setup.
Configure your communication protocol settings.
Configure Billing/TOU registers.
At this stage, the EM13X Series should be ready for operation.