SATEC EM132-133 Manual - Manual (Page 107)

‎Chapter 7 Monitoring M E T E R S
EM13x Series SMART MULTIFUNCTION METER 107
Organizing Data Sets
PAS supports 33 programmable data sets with up to 40 data
parameters. Set #0 is intended for simple meters, which have a limited
number of parameters, and is not recommended for the use with the
EM13X Series. To re-organize data sets, select RT Data Sets from the
Monitor menu or click on the button
on the local toolbar.
Some data sets are preset for your convenience and others are empty.
You can freely modify data sets.
See Appendix D for a list of data available in your meter.
Polling Options
To change the polling options, click on the Data Monitor window with
the right mouse button and select Options.
If you check Do not stop on errors, polling is resumed automatically
when a communication error occurs, otherwise polling stops until you
restart it manually.
Viewing a Data Table
Changing the Data View
PAS displays data in either a single record or multi-record view. To
change the view, click on the Data Monitor window with the right
mouse button and select either Wrap to see a single record, or
UnWrap to go to the multi-record view.
Adjusting the Number of Rows in a Multi-Record View
Click the window with the right mouse button, select Options, adjust
the number of records you want to see in the window, and then click
OK. When the number of retrieved records exceeds the number of rows
in the window, the window scrolls up so that older records are erased.