SATEC EM132-133 Manual - Manual (Page 66)

‎Chapter 5 Configuring T H E E M 1 3 X S E R I E S
66 EM13x Series SMART MULTIFUNCTION METER
Figure ‎5-4: eXpertPower Client Setup Tab
The following table lists available options. Refer to your eXpertPower
service provider for the correct network settings.
Table 6: eXpertPower Client Setup Options
Parameter Options Default Description
XPW Server IP Address 207.232.60.18 The IP address of the
eXpertPower server
XPW Server Port 0-65535 5001 The TCP service port of the
eXpertPower server
XPW Client Enabled NO, YES NO Enables operations of the
eXpertPower client
Time to Next Session,
min
1-99999 The time remaining to the
next connection session
NOTES
 Do not enable the eXpertPower client in your meter if
you do not use the eXpertPower
TM service.
 Do not change the connection time setting. It is for
information only. The eXpertPower server updates it
automatically.
Setting Up TCP Notification Client
The TCP notification client can establish connections with a remote
Modbus/TCP server and send notification messages either on events,
or periodically on a time basis.
To set up communications with a remote TCP Notification server, select
Communication Setup from the Meter Setup menu, and then click
on the TCP Notification Client Setup tab.