SATEC EM132-133 Manual - Manual (Page 70)

‎Chapter 5 Configuring T H E E M 1 3 X S E R I E S
70 EM13x Series SMART MULTIFUNCTION METER
Using the Front Display
Select Options from the main menu. See Viewing and Changing Setup
Options in Chapter 3 for information on configuring parameters via the
front display.
Using PAS
Select General Setup from the Meter Setup menu, and then click on
the Device Options tab.
Table 10 lists available device options.
Table 10: User-configurable Device Options
Display
Label
Parameter Options Default Description
TestMode Energy Test
Mode
Three options:
OFF = disabled
Wh pulses
varh pulses
Disabled Setting this option puts the
meter into the energy test
mode (see Energy Pulse
LED in Chapter 3)
PowMode Power
Calculation
Mode
Reactive = using reactive power
S=f(P, Q),
NonActive = using non-active
power Q=f(S, P)
S=f(P, Q) The method used for
calculating reactive and
apparent powers (see
Power Calculation Modes
below)
EngyRoll Energy Roll
Value
10000 = 10000 kWh
100000 = 100000 kWh
1000000 = 1000000 kWh
10000000 = 10000000kWh
100000000 = 100000000 kWh
1000000000 = 1000000000 kWh
10000000 The value at which energy
counters roll over to zero
Phs.Engy Phase Energy
Calculation
Disabled
Enabled
Disabled Enables phase energy
calculations
StrtVolt Starting
Voltage
1.5-5.0% 1.5% The device starting voltage
in percent of FS (120V or
400V)
Resolution Device
Resolution
Low
High
Low The voltage, current and
power resolution on the
front display (see
Measurement Units in
Chapter 3) and in
communications (see
communication guides)
Options TestMode
OFF