Quadrox QGuard User Manual - Manual (Page 98)

QGuard User Manual 98
Version 4.9 Series
Mosaic View Settings Screen
1. Specify a Name for the mosaic.
2. Select Frame rate.
3. Configure Sequence:
a. Select cameras from the drop-down lists.
b. Specify a Name for the sequence (step).
c. Specify Sequence time.
Sequence time is the time (in seconds) that is used to switch between all sequences
(steps). This is only relevant when two or more sequences (steps) are configured.
4. Add additional Sequences (optional).
Frame rate is the number of frames shown per second. This setting only applies to the
focus view, the small views by default have 1 fps as frame rate.
5. Click Apply button.
By default each mosaic view is created with the number of steps needed to involve all
available cameras.
You can delete a Step any time by clicking the Close button in upper right corner of
the Sequence (step) section.
To go back to the Mosaics Screen, click Cancel button.