Quadrox QGuard User Manual - Manual (Page 107)

QGuard User Manual 107
Version 4.9 Series
Importing Settings Screen
When the restore process is finished, an overview will be given outlining the results of your
restore action. In case a particular section was not (or partially) restored, it will be marked in
yellow or red. Move the mouse cursor over the results in order to see the detailed information
of that section.
Restore Results Screen
3.4.1.2 System Information
The System Information section describes the following parameters:
 Logged User – user that is logged in.
 Activation Code – activation code based on the machine and number of allowed
cameras.
When reinstalling or upgrading the QGuard software on the same machine, you can
reuse the Activation Code as long as crucial components as CPU, Motherboard or
Network Interface Card aren’t replaced. The Hard disk is not a crucial component.
It’s possible that the Activation Code is invalid if you have two different Network
Interface Cards installed on your machine. The Activation Code is based on one NIC
(Network Interface Card).
You can Upgrade your license in order to be able to monitor more cameras. Click the
Upgrade button in the Activation code row. You will be redirected to the Activation
page where you should specify the new key. To obtain this key, contact Quadrox or
your installer.