Quadrox QGuard User Manual - Manual (Page 80)

QGuard User Manual 80
Version 4.9 Series
3.3.3.4 NAMOS
The NAMOS device has to be configured at both sides. This means on the NAMOS software
side and at the QGuard side. We only discuss the QGuard side. For the NAMOS software
side, consult the NAMOS documentation.
In order to add and configure your POS device, click the Edit device or Add POS Device
link/button in the POS screen. The POS Device Configuration Wizard consists of four tabs
with easy to follow instructions.
In order to configure the sources, click the Edit link of the source in the POS screen which
will lead you to the POS configuration Wizard. The POS Configuration Wizard consists of
two tabs with easy to follow instructions.
The POS functionality is a part of the QGuard Alarm Component. You need the
Alarm Component installed before you can use the POS functionality.
You need to select the NAMOS driver in the custom menu when installing the Alarm
Component. By default only the Serial Port POS and Generic POS driver is installed
when installing the Alarm Component.
3.3.3.4.1 Device Name
In this tab, you can adjust the POS Device name. It’s a part of the POS Device
Configuration Wizard.
Name (NAMOS) Screen
Click Next to enter the next POS Device Configuration Wizard Screen.
3.3.3.4.2 Device Protocol
In this tab, the protocol has to be selected. It’s a part of the POS Device Configuration
Wizard.
Select NAMOS in the drop-down list.