Quadrox QGuard User Manual - Manual (Page 108)

QGuard User Manual 108
Version 4.9 Series
 Allowed Cameras – specifies the number of cameras that may be connected to the
system.
You can connect as many cameras as you like to the system, but only the number of
allowed cameras will be active. The system automatically selects which cameras are
active. At first, analogue slots will be replaced by network cameras if analogue
cameras are present. If all cameras are network cameras, there will be a selection
based on an internal mechanism.
 OS Version – version of operating system installed.
.
 XPe Build Version – build version of XPe operating system.
 Setup Version – QGuard software version installed.
 Setup Path – directory where the QGuard software is installed.
.
 Setup Date – date of installation.
3.4.2 Network Diagnostics
This section allows you to check the state of the ports (opened/closed) necessary for proper
operation of the software. It consists of two diagnostic functionalities:
 Port Scanning
 Camera Scanning
Network Diagnostics Screen