Quadrox QGuard User Manual - Manual (Page 55)

QGuard User Manual 55
Version 4.9 Series
3.3.2.2 PMD I/O Device
The PMD I/O device has to be added manually. To do so, follow the steps below:
1. Attach the PMD I/O Device to one of the USB ports of your QGuard.
PMD I/O Device supports USB 2.0.
2. Click Add PMD I/O Device button.
Alarms (PMD I/O Device) Screen
The PMD I/O Device Configuration Wizard will be opened for configuration.
3.3.2.2.1 Name
This screen shows basic information about the I/O Device. It contains two fields:
 Device type – general information about the type of I/O Device connected.
 Serial Number – enter the serial number of your I/O Device in this field.
To obtain the serial number of your PMD I/O Device, refer to PMD I/O Device
documentation or use the special tool that is located in the Support folder to set a new
serial number. (see 3.3.2.2.5 PMD I/O Serial Number)
Name (PMD I/O Device) Screen
Click Next to enter the next I/O Device Configuration Wizard Screen.