ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 63)

4
System Basics 45
Direct Selects in Flexi Mode
Direct selects can be placed into a flexi mode, which will remove
empty tiles. When {Select} is pressed, the {Show Flexi} button
will display.
.
Using Direct Selects
Direct selects allow access to a number of controls, including a channel select display. If there are
more items than can be viewed at once, you may view subsequent pages by using the page
touchbuttons ({Page
 }, {Page  }) by the direct selects.
When storing to direct selects (groups, palettes, presets, and so on), you may store directly to them
by pressing [Record] {Direct Select Key}. Direct selects are anchored to whole numbers, so targets
will be recorded to the specific location of the direct select. Direct select buttons with no data stored
show a light gray number in the lower right corner. This number indicates the whole number slot of
that button.
You can record decimal inserts to a direct select ({Group 7.1}, {Color Palette 15.5}, {Preset 6.94},
and so on). Doing so will fill un-stored slots in the bank of direct selects, but will not eliminate the
whole numbers those slots represent.
For Example:
Assume you have stored color palette 1 (button 1), color palette 1.1 (button 2), and color
palette 3 (button 3). If you record color palette 2, it will appear in the slot just after color
palette 1.1 and color palette 3 will be bumped one slot to the right. This will continue until
an open slot can absorb the displaced target.
N o t e : A single empty direct select tile may remain if the adjacent direct select tiles are
not sequential. This is to allow an easy way to insert a new direct select between
the existing ones.
On
Off
Show Flexi is off
Show Flexi is on