ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 390)

372 Eos Titanium, Eos, and Gio Operations Manual
Ping
Ping is used to test the network connection between two devices.
Output Protocols
This is for selecting which protocols the desk will output and which ones are included in the default.
.
sACN
This sets the control priority for sACN data from this desk. The valid range for this setting is 1
(lowest) to 200 (highest). This is the reverse of EDMX.
Eos and the Net3 Gateways support two versions of sACN, the draft version and the final ratified
version. The ratified version is outputted by default unless this is selected.
Net2-EDMX
This sets the control priority for EDMX data from this desk. The valid range for this setting is 20
(lowest) to 1 (highest). This is the reverse of sACN.
Avab UDP
This sets the subnet for Avab UDP data from this desk. The priority levels range from 0-200. The
default is 0, which is no priority level. 1 is the lowest priority level and 200 is the highest. When set
to no priority level (0), the data will merge according to HTP.
A backup desk will receive its Avab UDP priority level from the primary. The backup will then output
at one priority higher than the primary, unless the primary was set to the highest priority of 200.
N o t e : sACN can be output on both ports for Eos Ti and Gio. All other output protocols
can only be output on a single NIC.
Click to enter the IP
address of the device
you want to ping, and
then press {Start}.
Device is responding to
the ping.
Device is not responding
to the ping.