Storing palettes to direct selects, Using filters with palettes – ETC Eos Titanium, Eos, and Gio v2.0.0 User Manual
Page 190
172
Eos Titanium, Eos, and Gio Operations Manual
Storing Palettes to Direct Selects
You can store palettes efficiently using the direct selects. Rather than using the [...Palette] hard key
and the numeric keypad to specify a palette number, you can simply touch the desired direct select
for that palette from the touchscreen.
For Example:
If you want to store color data to color palette 4, press:
•
[Record]
and then press the button in the bank of color palette direct selects that is labeled in the
lower right corner with a light gray “4”.
•
{Color Palette Direct Select Button 4}
“Color Palette 4” will appear in the direct select, indicating a successful store.
For more information on direct select mapping, see
Using Filters with Palettes
Filters can be used to modify what data is stored to a palette by a record action. The parameters
that are active or filtered allow those parameters to be stored to record targets.
To filter a parameter:
Step 1:
Press and hold the [Filter] button on the face panel.
Step 2:
In the CIA, press the touchbutton for the parameter you wish to store.
Step 3:
Release the [Filter] button. “Filter On” appears next to the parameter category button.
To determine which parameter is filtered in the category:
Step 1:
Press and hold the [Filter] button. All actively filtered parameters are highlighted in
gray. You may need to press the arrow softkeys for that parameter category to page
additional parameters in the category.
Filters are a toggle state. To remove filters, press and hold [Filter] and press the highlighted
parameter buttons in the CIA to deactivate the filters, or use {Clear Filters}.
For more information on filters, see
.