ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 379)

30
Using Partitioned Control 361
Creating New Partitions
To create a new partition, press:
• {Partition} [x] [Enter] - where “x” is a number that does not yet exist in the partition list.
This will create a new partition, highlight it in the list, and (if partition is enabled) assign it as your
partition.
To assign channels to that partition, enter them in the command line:
• [1] [Thru] [9] [6] [Enter]
You can also use [+], [-], and [Group] to further modify the channels in the partition. When adding/
subtracting channels to a partition, if you do not use [+] or [-] before channel numbers, the numbers
will replace the channels in the partition, rather than adding to or subtracting from them. This
overwriting does require a confirmation (if enabled in setup).
When you are finished, you can press {Done} to return to the setup screen.
Deleting Partitions
To delete any partition, simply type the syntax in the command line:
• [Delete] {Partition} [5] [Enter] [Enter] - deletes partition 5 from the list.
Preprogrammed partitions cannot be deleted.