CHAMPION EEUCCW8 - Manual (Page 53)

45
Troubleshooting
PROBLEM CAUSE SOLUTION
Conveyor belt will
not move.
Mode switch not operated. Push Energy Saver, Normal, or Fast
Mode Selector Switch
Conveyor Stop Switch pressed. See above.
Remote Stop Switch pressed. Press Remote Start Switch.
Conveyor Shut-off Shelf in stop
position.
Push Shut-off Shelf to the Run position.
Conveyor belt jammed. Turn dishwasher power switch off.
Check for jam and free belt.
Conveyor motor overload tripped
or defective.
Call service agent.
1 or moter
wash pump will
not run.
Wash motor overload tripped.
Defective motor.
Call service agent.
Water level in
1 or more tanks
low.
Door not closed completely. Close door.
Water runs
constantly.
Stuck or defective float switch.
Water pressure high.
Clean or replace float switch.
Adjust PRV or reduce incoming water
pressure.
Clogged solenoid valve line strainer. Clean line strainer.
Defective solenoid valve. Repair/replace valve. Call service agent.
Float switch stuck/clogged with lime. Free stuck float. Clean/de-lime dishwasher
(Consult chemical supplier).
Tank scrap screens clogged. Clean scrap screens.
Tank cross-flow piping clogged. Drain dishwasher and clean.
Drain valve open. Close drain valve.