CHAMPION EEUCCW8 - Manual (Page 32)

24
Installation
Installation
1. Check the interior of the machine and remove any foreign material.
2. Check the scrap screens, pump strainers and scrap baskets are properly installed.
3. Check the exterior of the machine — make sure that the conveyor belt is free of tape and foreign
material.
4. Vent stacks must be placed on the hood with vent handles facing the front of the dishwasher
5. Open the water supply valves. Check for leaks and take corrective action as required.
6. Open the steam supply valves (if applicable). Check for leaks and take corrective action if required.
7. Turn the main power on at the breaker panel or fused disconnect switch.
8. Flip the Power Switch on the front of the Control Cabinet to the "ON" position.
The machine will begin to fill with water. The water will shut off automatically.
9. Check for leaks and take corrective action if required.
10. Allow sufficient time for the tank heat to reach operating temperature.
then check that the digital temperature meters indicate the proper temperature readings.
11. Move the conveyor shut-off shelf located at the end of the unload section toward the load end of
the machine. This resets the automatic conveyor stop system.
12. Press each mode switch and then the stop switch in succession to check conveyor belt drive
operation.
13. Open each door to ensure the door safety switches shut the machine off.
14. Operate the conveyor shut-off assembly to ensure the conveyor stops when operated.
15. Check the direction of rotation of the conveyor belt by observing the direction arrow decal on the
large conveyor drive sprocket. The sprocket is located on the side of the unload section.
If rotation direction is incorrect, reverse wires L1 and L2 on the disconnect switch side of the main
electrical connection terminal block located inside the control cabinet.
16. Check the conveyor drive clutch adjustment.
The clutch should be CHECKED AND ADJUSTED MONTHLY.
17. Check the alignment of the conveyor belt.
18. Check the Energy Sentinel (idle pump shut-off) by placing a tray or dish on the moving conveyor
belt. The pumps should start when the object breaks the infrared beam on the entrance end
of the dishwasher.
19. Make sure the panels are properly installed. The panels are marked with location numbers and
should match the numbers located on the dishwasher.
20. Make sure the curtains are properly installed.
21. Turn the dishwasher power switch to the OFF position.
22. Open the dishwasher drains and make sure the building drain system handles the drain flow.
23. Make sure the dish room is neat and clean.
Check List
Perform the following checks and adjustments before placing the machine into service.