CHAMPION EEUCCW8 - Manual (Page 36)

28
Operation
Operation
Summery of Operation
The steps below explain the basic operation of the dishwasher. Detailed instructions follow this summery.
14. When wash tank temperature readings are correct then push the NORMAL mode selector switch.
- The green LED will illuminate and the conveyor will start.
Select the FAST mode selector switch.
- The Fast LED will illuminate and the conveyor speed will increase.
15. Scrap and pre-rinse wares, sort and place on the conveyor belt to wash. When the wares break the
infrared beam at the entrance of the wash tunnel:
- The wash pumps run.
- If equipped, the optional blower dryer runs.
- If equipped, the optional Heat Recovery Unit runs.
NOTE: The dishwasher will run automatically as long as wares break the infrared beam.
The automatic time cycle ends when the last item placed on the belt has been washed,
sanitized and exited the machine.
16. Wares move on the conveyor belt through the wash tanks and the final rinse section for sanitizing.
The blower dryer aids the drying of the wares.
The heat recovery unit captures residual heat from the dishwasher reducing energy costs.
17. Clean wares exit the dishwasher. If wares touch the conveyor shut-off shelf:
- The automatic timed cycle pauses.
- The conveyor belt stops.
- The blower dryer operates for 30 additional seconds and stops.
- The wash pumps stop.
18. Clear the belt area of wares and return the conveyor shut-off shelf to the ON position.
- The automatic timed cycle resumes.
- The conveyor belt runs.
- The wash pumps run.
- The blower dryer runs.
- The heat recovery unit runs.
19. When the last item placed on the belt exits the machine:
- Remove the item.
- The pumps automatically stop.
- The blower dryer stops after running 30 more seconds.
- The heat recovery unit stops.
- The conveyor belt continues to run.
NOTE: The machine operation will stop whenever the STOP button on the main control cabinet or
a remote stop/start station is pressed. Operation will resume when the remote start
button is pressed or a Mode Switch on the control cabinet is pressed.
The dishwasher conveyor, pumps, and blower dryer turn off whenever a door is opened.
Push a start button or mode switch to resume operation.