CHAMPION EEUCCW8 - Manual (Page 17)

9
Installation
Installation
Joining the Sections
1. Bolt all the HOOD sections
together with twenty (20),
5/16-18 X 3/4" bolts,
lockwashers and nuts
included in the hardware kit.
2. Tighten the hood bolts in
a cross-pattern to pull the
sections together.
3. Silicon sealant should
squeeze out of the section
joints.
4. Bolt the section bases
together using three (3) 1/2-
13 X 1" bolts, lockwashers,
and nuts from the hardware
kit.
5. Recheck the level of the
assembled sections and
adjust as needed to achieve
a level line between the
joined sections.