Apple Logic Express 9 - Manual (Page 1176)

µ
Click the Settings button in the Arrange toolbar, then choose Metronome from the pop-up
menu.
µ
Control-click the Metronome button in the Transport bar, then choose Metronome Settings
from the shortcut menu.
MIDI Click Settings
• Bar checkbox: Select to generate separate note events for bars.
• Beat checkbox: Select to generate separate note events for beats.
• Division checkbox: Select to generate separate note events for divisions.
• Channel fields: Define the MIDI channel of generated notes.
• Note fields: Define the note number of generated notes.
• Velocity fields: Define the velocity of generated notes.
• MIDI Port pop-up menu: Allows you to choose a direct MIDI output port (or all ports)
for the metronome.
Software Click Instrument (KlopfGeist) Settings
• Software Click Instrument (KlopfGeist) checkbox: Activates or deactivates the KlopfGeist
metronome.
• Bar checkbox: Select to generate separate note events for bars.
• Beat checkbox: Select to generate separate note events for beats.
• Division checkbox: Select to generate separate note events for divisions.
• Note fields: Define the note number of generated notes.
• Velocity fields: Define the velocity of generated notes.
• Tonality slider: Changes the sound of the virtual metronome from a short click to a
pitched percussion sound, similar to a wood block or claves.
• Volume slider: Sets the output level of the virtual click sound.
• Output pop-up menu: If the audio hardware used by Logic Express offers more than
two outputs, this pop-up menu allows you to route the KlopfGeist metronome sound
to a different set of hardware outputs.
Other Metronome Settings
• “Click while recording” checkbox: The metronome click is automatically turned on for
recording. This is the same as activating the Metronome button in the Transport bar
during recording.
• “Only during count-in” checkbox: When this option is active, the recording click is only
audible during the project count-in, and is then turned off.
1176 Chapter 42 Project Settings in Logic Express