Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 94)

76 Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Configuring IP parameters – Layer 3 Switches
Deploying an address pool configuration to the server
The deploy command sends an address pool configuration to the DHCP server.
Brocade(config-dhcp-cabo)# deploy
Syntax: deploy
Specifying default routers available to the client
The dhcp-default-router command specifies the ip addresses of the default routers for a client.
Syntax: dhcp-default-router address [address, address]
Specifying DNS servers available to the client
The dns-server command specifies DNS servers that are available to DHCP clients.
Brocade(config-dhcp-cabo)# dns-server 192.168.1.143, 192.168.2.142
Syntax: dns-server address [address. address]
Configuring the domain name for the client
The domain-name command configures the domain name for the client.
Brocade(config-dhcp-cabo)# domain-name sierra
Syntax: domain-name domain
Configuring the lease duration for the address pool
The lease command specifies the lease duration for the address pool. The default is a one-day
lease.
Brocade(config-dhcp-cabo)# lease 1 4 32
In this example, the lease duration has been set to one day, four hours, and 32 minutes. You can
set a lease duration for just days, just hours, or just minutes, or any combination of the three.
Syntax: lease days hours minutes
Specifying addresses to exclude from the address pool
The excluded-address command specifies either a single address, or a range of addresses that are
to be excluded from the address pool.
Brocade(config-dhcp-cabo)# excluded-address 192.168.3.44
Syntax: excluded-address [address | address-low address-high]
• address - Specifies a single address
• address-low address-high - Specifies a range of addresses