Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 295)

Brocade ICX 6650 Layer 3 Routing Configuration Guide 277
53-1002603-01
Displaying OSPF V3 Information
Syntax: show ipsec statistics
This command takes no parameters.
Displaying IPsec configuration for an area
The show ipv6 ospf area [area-id] command includes information about IPsec for one area or all
areas. In the example that follows, the IPsec information is in bold. IPsec is enabled in the first
area (area 0) in this example but not in area 3. Note that in area 3, the IPsec key was specified as
not encrypted.
Syntax: show ipv6 ospf area [area-id]
The area-id parameter restricts the display to the specified OSPF area. You can specify the area-id
parameter in the following formats:
• An IPv4 address, for example, 192.168.1.1
• A numerical value in the range 0–2,147,483,647
TABLE 59 Area configuration of IPsec
Field Description
Authentication This field shows whether or not authentication is configured. If this field says
“Not Configured,” the IPsec-related fields (bold in example screen output) are
not displayed at all.
KeyRolloverTime The number of seconds between each initiation of a key rollover. This field
shows the configured and current times.
KeyRolloverState Can be:
Not active: key rollover is not active>
Active phase 1: rollover is in its first interval.
Active phase 2: rollover is in its second interval.
Current Shows current SPI, authentication algorithm (currently ESP only), encryption
algorithm (currently SHA1 only), and the current key.
Brocade(config-ospf6-router)#show ipv6 ospf area
Authentication: Configured
KeyRolloverTime(sec): Configured: 25 Current: 20
KeyRolloverState: Active,Phase1
Current: None
New: SPI:400, ESP, SHA1
Key:$Z|83OmYW{QZ|83OmYW{QZ|83OmYW{QZ|83OmYW{Q
Interface attached to this area: eth 1/1/1
Number of Area scoped LSAs is 6
Sum of Area LSAs Checksum is 0004f7de
Statistics of Area 0:
SPF algorithm executed 6 times
SPF last updated: 482 sec ago
Current SPF node count: 1
Router: 1 Network: 0
Maximum of Hop count to nodes: 0
Area 3:
Authentication: Not Configured
Interface attached to this area:
Number of Area scoped LSAs is 3