Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 235)

Brocade ICX 6650 Layer 3 Routing Configuration Guide 217
53-1002603-01
Displaying OSPF information
The area-id parameter shows information for the specified area.
The num parameter displays the entry that corresponds to the entry number you enter. The entry
number identifies the entry position in the area table.
This display shows the following information.
Displaying OSPF neighbor information
To display OSPF neighbor information, enter the following command at any CLI level.
To display detailed OSPF neighbor information, enter the following command at any CLI level.
Syntax: show ip ospf neighbor [router-id ip-addr] | [num] | [detail]
The router-id ip-addr parameter displays only the neighbor entries for the specified router.
TABLE 36 CLI display of OSPF area information
Field Definition
Indx The row number of the entry in the router OSPF area table.
Area The area number.
Type The area type, which can be one of the following:
•
nssa
•
normal
•
stub
Cost The area cost.
SPFR The SPFR value.
ABR The ABR number.
ASBR The ABSR number.
LSA The LSA number.
Chksum(Hex) The checksum for the LSA packet. The checksum is based on all the fields in the packet
except the age field. The Layer 3 Switch uses the checksum to verify that the packet is
not corrupted.
Brocade#show ip ospf neighbor
Port Address Pri State Neigh Address Neigh ID
1/1/8 192.168.7.251 1 full 192.168.7.200 192.168.1.220
Brocade#show ip ospf neighbor detail
Port Address Pri State Neigh Address Neigh ID Ev Op Cnt
1/1/9 10.2.0.2 1 FULL/DR 10.2.0.1 192.168.2.2 6 2 0
Second-to-dead:39
1/1/10 10.3.0.2 1 FULL/BDR 10.3.0.1 192.168.3.3 5
2 0
Second-to-dead:36
1/1/1-1/1/8 10.5.0.1 1 FULL/DR 10.5.0.2 192.168.16.16 6 2 0
Second-to-dead:33
1/2/1-1/2/2 10.2.0.1 1 FULL/DR 10.2.0.2 192.168.15.15 6 2 0
Second-to-dead:33