Displaying cpu utilization statistics – Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 User Manual
Page 133

Brocade ICX 6650 Layer 3 Routing Configuration Guide
115
53-1002603-01
Displaying IP configuration information and statistics
Displaying CPU utilization statistics
You can display CPU utilization statistics for IP protocols using the show process cpu command.
The show process cpu command includes CPU utilization statistics for ACL, 802.1x, and L2VLAN.
L2VLAN contains any packet transmitted to a VLAN by the CPU, including unknown unicast,
multicast, broadcast, and CPU forwarded Layer 2 traffic.
To display CPU utilization statistics for the previous one-second, one-minute, five-minute, and
fifteen-minute intervals, enter the following command at any level of the CLI.
Distance
The administrative distance of the route. The default administrative distance for static IP
routes in Brocade routers is 1.
To list the default administrative distances for all types of routes or to change the
administrative distance of a static route, refer to
“Changing the administrative distance”
Policies
Index
The policy number. This is the number you assigned the policy when you configured it.
Action
The action the router takes if a packet matches the comparison values in the policy. The
action can be one of the following:
•
deny – The router drops packets that match this policy.
•
permit – The router forwards packets that match this policy.
Source
The source IP address the policy matches.
Destination
The destination IP address the policy matches.
Protocol
The IP protocol the policy matches. The protocol can be one of the following:
•
ICMP
•
IGMP
•
IGRP
•
OSPF
•
TCP
•
UDP
Port
The Layer 4 TCP or UDP port the policy checks for in packets. The port can be displayed by its
number or, for port types the router recognizes, by the well-known name. For example, TCP
port 80 can be displayed as HTTP.
NOTE: This field applies only if the IP protocol is TCP or UDP.
Operator
The comparison operator for TCP or UDP port names or numbers.
NOTE: This field applies only if the IP protocol is TCP or UDP.
TABLE 16
CLI display of global IP configuration information – Layer 3 Switch (Continued)
Field
Description