Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 User Manual
Page 471

Brocade ICX 6650 Layer 3 Routing Configuration Guide
453
53-1002603-01
Displaying VRRP and VRRP-E information
Syntax: show ip vrrp vrid num [ethernet num | ve num]
Syntax: show ipv6 vrrp vrid num [ethernet num | ve num]
The num variable specifies the VRID.
The ethernet num | ve num options specify an interface on which the VRID is configured. If you
specify an interface, VRID information is displayed for that interface only. Otherwise, information is
displayed for all the interfaces on which the specified VRID is configured.
shows a description of the output for the show ip vrrp vrid command.
TABLE 83
Output from the show ip vrrp vrid command
Field
Description
VRID
The specified VRID.
Interface
The interface on which VRRP is configured.
State
This Layer 3 switch VRRP state for the VRID. The state can be one of the
following:
•
Init – The VRID is not enabled (activated). If the state remains Init after
you activate the VRID, make sure that the VRID is also configured on the
other routers and that the routers can communicate with each other.
NOTE: If the state is Init and the mode is incomplete, make sure you have
specified the IP address for the VRID.
•
Backup – This Layer 3 switch is a Backup for the VRID.
•
Master – This Layer 3 switch is the Master for the VRID.
priority
The configured VRRP priority of this Layer 3 switch for the VRID.
current priority
The current VRRP priority of this Layer 3 switch for the VRID.
track priority
The new VRRP priority that the router receives for this VRID if the interface goes
down.
hello interval
How often the Master router sends Hello messages to the Backups.
dead interval
The amount of time a Backup waits for a Hello message from the Master before
determining that the Master is dead.
Brocade#show ipv6 vrrp vrid 1
VRID 1
Interface ethernet 5
state backup
administrative-status enabled
version v3
mode non-owner(backup)
priority 100
current priority 100
hello-interval 1000 msec
dead-interval 0 msec
current dead-interval 3000 msec
preempt-mode true
ip-address 2001:db8:a7a7::1
virtual mac address 0000.0000.0201
advertise backup: enabled
next hello sent in 00:00:38.0
track-port 1/1/5(up)
master router 2001:db8:212:f2ff:fea8:5b00 timer expires in 00:00:02.6