Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 238)

220 Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Displaying OSPF information
Displaying OSPF route information
To display OSPF route information for the router, enter the show ip ospf routes command at any CLI
level.
Syntax: show ip ospf routes [ip-addr]
The ip-addr parameter specifies a destination IP address. If you use this parameter, only the route
entries for that destination are shown.
This display shows the following information.
Type The area type, which can be one of the following:
•
Broadcast = 0x01
•
NBMA = 0x02
•
Point to Point = 0x03
•
Virtual Link = 0x04
•
Point to Multipoint = 0x05
Events OSPF Interface Event:
•
Interface_Up = 0x00
•
Wait_Timer = 0x01
•
Backup_Seen = 0x02
•
Neighbor_Change = 0x03
•
Loop_Indication = 0x04
•
Unloop_Indication = 0x05
•
Interface_Down = 0x06
•
Interface_Passive = 0x07
Adjacent Neighbor Count The number of adjacent neighbor routers.
Neighbor: The neighbor router ID.
TABLE 39 CLI Display of OSPF route information
Field Definition
Index The row number of the entry in the router OSPF route table.
Destination The IP address of the route's destination.
TABLE 38 Output of the show ip ospf interface command (Continued)
Field Definition
Brocade#show ip ospf routes
Index Destination Mask Path_Cost Type2_Cost Path_Type
1 192.168.7.0 255.255.255.0 1 0 Intra
Adv_Router Link_State Dest_Type State Tag Flags
192.168.1.220 10.95.7.251 Network Valid 00000000 7000
Paths Out_Port Next_Hop Type Arp_Index State
1 1/1/5 192.168.7.250 OSPF 8 84 00
Index Destination Mask Path_Cost Type2_Cost Path_Type
2 10.3.63.0 255.255.255.0 11 0 Inter
Adv_Router Link_State Dest_Type State Tag Flags
192.168.7.250 10.3.63.0 Network Valid 00000000 0000
Paths Out_Port Next_Hop Type Arp_Index State
1 1/1/6 192.168.7.250 OSPF 8 84 00