Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 286)

268 Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Displaying OSPF V3 Information
Syntax: show ipv6 ospf redistribute route [ipv6-prefix]
The ipv6-prefix parameter specifies an IPv6 network prefix. (You do not need to specify the length
of the prefix.)
For example, to display redistribution information for the prefix 2002::, enter the show ipv6 ospf
redistribute route command at any level of the CLI.
These displays show the following information.
Displaying OSPF V3 route information
You can display the entire OSPF V3 route table for the Brocade device or only the route entries for a
specified destination.
To display the entire OSPF V3 route table for the device, enter the show ipv6 ospf routes command
at any level of the CLI.
TABLE 51 OSPF V3 redistribution information
Field Description
ID An ID for the redistributed route.
Prefix The IPv6 routes redistributed into OSPF V3.
Protocol The protocol from which the route is redistributed into OSPF V3. Redistributed protocols can
be the following:
•
RIP – RIPng.
•
Static – IPv6 static route table.
•
Connected – A directly connected network.
Metric Type The metric type used for routes redistributed into OSPF V3. The metric type can be the
following:
•
Type-1 – Specifies a small metric (2 bytes).
•
Type-2 – Specifies a big metric (3 bytes).
Metric The value of the default redistribution metric, which is the OSPF cost of redistributing the
route into OSPF V3.
Brocade#show ipv6 ospf redistribute route
Id Prefix Protocol Metric Type Metric
snIpAsPathAccessListStringRegExpression
1 2001:db8::/16 Static Type-2 1
2 2001:db8::/32 Static Type-2 1
Brocade#show ipv6 ospf redistribute route 2001:db8::
Id Prefix Protocol Metric Type Metric
1 2001:db8::/16 Static Type-2 1